Part No: Issued year: 2014File size: 0.34mbFile type: pdf
In this poster, an IONICS 3Q 220 triple quadrupole mass spectrometer using a load, wash, elute method protocol with recently advanced solid phase extraction (SPE) sorbent technology (EVOLUTE EXPRESS WCX) was used to perform analysis of the two compounds. As a result low levels of metanephrine and normetanephrine are detectable in plasma with short sample preparation and LC run times. This LC-MS/MS method provides a fast, sensitive, accurate, and reproducible solution for the analysis of ME and NME in plasma.
Part No: AN303Issued year: 2007File size: 0.14mbFile type: pdf
Heck reactions utilizing a thermostable catalyst in combination with microwave irradiation have been performed. A substantial enhancement of reaction rates as well as excellent regiocontrol could be obtained under microwave conditions without using inert gas. A slight increase in yield was also noted.
Part No: CM-HMPB-0810Issued year: 2010File size: 0.29mbFile type: pdf
For peptides acid, we recommend using the HMPB-ChemMatrix
as this resin will provide high crude purity and a recovery yield of
90-95%. The Wang-ChemMatrix will produce similar crude
peptide purity, but the recovery yield is lower (60-70%). On
request, we can provide preloaded HMPB-ChemMatrix resins with
all 20 naturally occurring amino acids. Other amino acids can be
preloaded on special request.
Part No: TN0171704_01Issued year: 2017File size: 1.18mbFile type: pdf
When a new piece of equipment is introduced the question is always raised about performance. Does it perform as well as its predecessor? What about the performance over time? This technical note will provide data to describe the performance of the SPE-DEX 5000, providing solid phase disk extraction (SPE), compared to standards required by environmental methods.
Part No: TN0101510_01Issued year: 2015File size: 0.45mbFile type: pdf
The quality of the solid phase disk used for extraction is key to the success and ease of an analysis. Horizon Technology’s Pacific™ Premium Oil & Grease SPE disks for Method 1664/ISO 11349 meet all Initial Precision and Recovery (IPR), Method Detection Limit (MDL) and Ongoing Precision and Recovery (OPR) limits specified by the US EPA, while saving the lab extraction time and solvent volume. Both 47 and 100-mm disks are fast-flowing and have a high-retention capability, which increases efficiency without compromising recoveries.
Part No: AN747Issued year: 2011File size: 0.18mbFile type: pdf
Biotage® PRESSURE+ manifolds deliver positive pressure, parallel processing for 96 well plates and column formats. The systems utilize a consistent, uniform flow of positive pressure to move both low and high viscosity liquids through SPE plates and columns. ISOLUTE SLE+ Supported Liquid Extraction plates and columns offer an efficient alternative to traditional liquid-liquid extraction (LLE) for bioanalytical sample preparation, providing high analyte recoveries, no emulsion formation and greatly matrix effects associated with biofluid analysis.
SLE+, SLE, Supported Liquid Extraction, positive pressure manifold, Pressure+96, Pressure+48
Part No: UI333Issued year: 2015File size: 0.89mbFile type: pdf
If high back pressure is detected in the makeup pump lines, and/or the High Makeup Flow Pressure dialog appears, the microfilter may be partially clogged and needs replacing. This is a step by step guide.
Part No: UI319.v3Issued year: 2017File size: 0.7mbFile type: pdf
Biotage®SNAP Ultra cartridges are compatible with CombiFlash® Rf Systems. As a convenience, Biotage SNAP Ultra cartridges with Luer slip connectors are available. Contact your Biotage representative for ordering information.
Part No: TechTipIssued year: 2011File size: 0.07mbFile type: pdf
Are you keeping up with your annual six month Hydrophilic Solution treatments for your SPE-DEX 4790 or 1000/3000 SPE-DEX instruments?
1. The water sample will not flow down into the disk holder.
2. My water inlet valve may not be opening
3. My water inlet valve is opening, but my sample is not dispensing into the disk holder.
4. My entire collection vessel is filled with the water sample.
Part No: AN078Issued year: 2013File size: 1.05mbFile type: pdf
In this application note we demonstrate the power of mass detection in Isolera™ Dalton by investigating the incomplete separation of two dyes, Butter yellow (Mass 225.29 g/mol) and Sudan red (Mass 278.31 g/mol), by normal phase flash purification.
Part No: P053Issued year: 2013File size: 1.22mbFile type: pdf
Immunosuppressant drugs are extremely important for therapeutic drug monitoring (TDM) regimes, requiring robust and reliable methods for their analysis. This poster aims to demonstrate strategies for the extraction of various immunosuppressant drugs from whole blood providing clean samples prior to UPLC-MS/MS analysis. Spiked whole blood was extracted using a variety of protocols to investigate optimal combination of drug recovery and extract cleanliness. UPLC-MS/MS was conducted using a Waters ACQUITY UPLC coupled to a Quattro Premier XE triple quadrupole mass spectrometer. Acceptable extraction recoveries were obtained showing excellent extract cleanliness, demonstrating a reliable method for mass spectrometric approaches for these analytes.
Immunosuppressants, SLE, Supported Liquid Extraction, ISOLUTE, MSACL, San Diego, 2013
Part No: P140Issued year: 2016File size: 0.31mbFile type: pdf
Reversed-phase chromatography is typically used when you need to separate several milligrams of relatively polar compounds that either are not soluble in normal-phase solvents or are not compatible with bare silica
because they react, stick, or both. If you are currently using reversed-phase at preparative scale, such as flash chromatography, you know the mobile phase limitations – water with either methanol, acetonitrile, or
THF. As with normal-phase flash chromatography, when it comes time to purify you want your crude sample fully solubilized in the weakest possible solvent at the highest possible concentration.