Part No: P158Issued year: 2017File size: 0.27mbFile type: pdf
As reversed-phase flash chromatography gains traction in
medicinal chemistry labs the need to monitor its cost and
safety are becoming more important. Commonly used
reversed-phase solvents typically include water with an
organic solvent such as methanol or acetonitrile – each
have advantages and disadvantages.
Part No: AN801Issued year: 2003File size: 0.27mbFile type: pdf
The heat flow parameter can be used to monitor the progress of a reaction, and can be useful
in determining reaction rates. A heat flow probe study was executed on the Advantage
Series™ 3400 process chemistry workstation for the hydrolysis of acetic anhydride in water
at temperatures from 25 to 55 °C. The observed rate constant for the hydrolysis was determined
from the heat flow measurements. An Eyring plot was produced and the enthalpy and
entropy of activation were determined. Finally, the heat of reaction was measured based on
the total amount of heat that was observed during the hydrolysis.
Part No: AN036Issued year: 2001File size: 0.55mbFile type: pdf
Activated carbon is an adsorbent media used to remove colored compounds from solution. Using this media in the Biotage FLASH-AC cartridge as a packed bed improves adsorbent performance. Increasing the temperature of the solvent modifies adsorption and alters performance of the decolorization process. Elevated temperatures increase product solubility, therefore requiring less solvent than at room temperature. The increased concentration of product in a hot solution also simplifies crystallization.
Part No: AN040Issued year: 2003File size: 0.4mbFile type: pdf
Research in CNS drugs is primarily centered on nitrogen heterocycle chemistry. Basic amines are difficult to purify using traditional silica chromatography because of strong interactions between acidic silica and the molecules’ basic amine groups. These interactions cause band spreading and poor compound recovery. Solutions employed to counteract this phenomena include adding a competing amine (e.g. triethyl amine or ammonium hydroxide) to the flash chromatography solvent system or using reversed-phase HPLC with a buffered solvent system.
Part No: AN118-HOR.V.2Issued year: 2017File size: 1.33mbFile type: pdf
Hexane extractable material (HEM), also known as Oil & Grease extraction is a simple water quality measurement. The measurement can be used to assess pollution for compliance or as a measure of influent contamination to protect a waste treatment plant from levels that might cause malfunction.
Part No: P172Issued year: 2017File size: 0.49mbFile type: pdf
We investigate the use of reversed-phase high performance flash chromatography (HPFC) to quickly purify large quantities of crude synthetic peptides.
(6th Solid Phase Peptide Synthesis Symposium & 12th Australian Peptide Conference, Queensland, Australia, Oct. 2017)
Part No: Issued year: 2018File size: 0.66mbFile type: pdf
This poster presents a high sensitivity method for extraction and analysis of estrogens in human plasma. Sample preparation utilizes Biotage ISOLUTE SLE+ plates, providing high analyte recovery and low matrix effects.
MSACL 2018, Palm Spings, CA
Part No: AN041-HORIssued year: 2010File size: 0.83mbFile type: pdf
This application note investigates the applicability of automated solid phase extraction using the Biotage(r) Horizon 4790 extractor and DryDisk solvent drying system to extraction of a wide range of different compounds from phenols, to triazines, to organochlorine and organophosphorous pesticides spiked into tap water at a concentration of 1 ug/L.
Part No: Issued year: 2014File size: 0.34mbFile type: pdf
In this poster, an IONICS 3Q 220 triple quadrupole mass spectrometer using a load, wash, elute method protocol with recently advanced solid phase extraction (SPE) sorbent technology (EVOLUTE EXPRESS WCX) was used to perform analysis of the two compounds. As a result low levels of metanephrine and normetanephrine are detectable in plasma with short sample preparation and LC run times. This LC-MS/MS method provides a fast, sensitive, accurate, and reproducible solution for the analysis of ME and NME in plasma.
Part No: AN303Issued year: 2007File size: 0.14mbFile type: pdf
Heck reactions utilizing a thermostable catalyst in combination with microwave irradiation have been performed. A substantial enhancement of reaction rates as well as excellent regiocontrol could be obtained under microwave conditions without using inert gas. A slight increase in yield was also noted.
Part No: CM-HMPB-0810Issued year: 2010File size: 0.29mbFile type: pdf
For peptides acid, we recommend using the HMPB-ChemMatrix
as this resin will provide high crude purity and a recovery yield of
90-95%. The Wang-ChemMatrix will produce similar crude
peptide purity, but the recovery yield is lower (60-70%). On
request, we can provide preloaded HMPB-ChemMatrix resins with
all 20 naturally occurring amino acids. Other amino acids can be
preloaded on special request.
Part No: PPS535Issued year: 2017File size: 0.8mbFile type: pdf
When a new piece of equipment is introduced the question is always raised about performance. Does it perform as well as its predecessor? What about the performance over time? This technical note will provide data to describe the performance of the SPE-DEX 5000, providing solid phase disk extraction (SPE), compared to standards required by environmental methods.
Part No: PPS538.V.1Issued year: 2015File size: 0.29mbFile type: pdf
The quality of the solid phase disk used for extraction is key to the success and ease of an analysis. Horizon Technology’s Pacific™ Premium Oil & Grease SPE disks for Method 1664/ISO 11349 meet all Initial Precision and Recovery (IPR), Method Detection Limit (MDL) and Ongoing Precision and Recovery (OPR) limits specified by the US EPA, while saving the lab extraction time and solvent volume. Both 47 and 100-mm disks are fast-flowing and have a high-retention capability, which increases efficiency without compromising recoveries.
Part No: UI402Issued year: 2019File size: 0.36mbFile type: pdf
Confidence is what you need before you separate your precious
compound on a new brand of flash chromatography column.
Predictably getting your compound in a pure state is what you
want, and if you can get it faster and use less solvent all the
better. After all, your project needs to be completed on time,
and trying something new is not always appealing.
In order to take your first steps toward gaining that confidence
you can follow the same procedures we use here at Biotage to